// SYS_MODULE: RIGGING_HARDWARE_V1
CLAMP-ON HANG POINTS / NO ADHESIVE / NO DRILLING / NASHVILLE TN
A two-piece clamp-on shaft collar and a rated lifting eyebolt turn any run of LED pixel rope into a hang point. The collar splits in half, wraps the tube, and two vertical M6 cap screws pull it closed. Nothing bonds to the neon, nothing pierces it, and the ring slides off clean when the run gets re-cut for the next job.
// AVAILABLE BORES
Same collar design, same eyebolt, same placement rule. Only the bore changes to match the rope.
Every LumiRope profile has a ring that fits it — 20mm for the LumiRope 270 HD (RGBW), 22mm or 40mm for the LumiRope 360 HD (RGB). See the rope catalog →
* 22MM AND 20MM DIMENSIONS BEYOND BORE NOT PUBLISHED — CONFIRM AT ORDER.
// BILL OF MATERIALS
| PART | SPEC | DETAIL |
|---|---|---|
| Two-Piece Clamp-On Shaft Collar | 40mm bore, 55mm across flats, 60mm height, 15mm width, M6 tapped | Splits in half, clamps the tube. Top and bottom faces carry the tapped mounts. |
| Socket Head Cap Screws (2) | M6 x 16mm | Vertical — drop down through the upper ear into the tapped lower ear. |
| Shouldered Lifting Eyebolt | M6 x 1mm thread, 19mm closed eye, 400 lb vertical capacity | Zinc-plated steel. Threads into the top tapped mount. |
// INSTALL SEQUENCE
Back out both cap screws and separate the two half-shells.
Wrap both halves around the rope at the mark. Bore matches tube OD.
Drop both M6 screws down through the ears. Snug evenly, do not crush the tube.
Into the top tapped mount, then clip your safety.
// PLACEMENT RULE
At the non-cable end, as close to the end as possible.
15 ft in from that same end, at the swag point.
One ring at each segment end, plus one every 4–5 m of run.
NOTE: PIXEL 1 ORIENTATION IS THE CABLE END (GROUND / CONTROL BOX SIDE).
// FIELD PROVEN
// RENT OR BUILD
Rings ship with KG3 rope rentals, or we fit them to your existing tube. Tell us the profile and we spec the bore.